The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Superficial Rockwell Analog Tester (900-345)

Write a Review
200.00 LBS
$275.00 (Fixed Shipping Cost)
  • Base Cabinet for Rockwell, Brinell and Vickers Hardness Testers

Just like our Phase II analog Rockwell Hardness Tester, the 900-345 Superficial Rockwell Hardness Tester comprises "state of the art" design and dynamic precision only found at Phase II. Used for testing thin and soft material in the Superficial Rockwell Hardness scales, this hardness tester is ruggedly engineered to obtain highly sensitive and accurate readings. Conforming to ASTM E-18 Superficial Rockwell Hardness standards, this hardness tester will offer unmatched repeatability in all Superficial Rockwell Hardness scales (table shown below). A perfect performer suited for any environment including heat treat facilities, tool rooms, workshops, laboratories and inspection labs. Lifetime technical support is included with all Phase II Hardness Testers. So test away with confidence and a level of accuracy you will only find at Phase II.


  • Direct analog dial reading
  • Engineered to obtain highly sensitive and accurate readings
  • Conforms to ASTM E-18
  • Perfect for laboratories, workshops, tool rooms, inspection labs, etc.
  • For testing thin, soft material in the Superficial Rockwell scales (900-345)


Minor Load

3 Kgf

Major Load 15 Kgf, 30 Kgf, 45 Kgf
Test Force Application Dead Weight
Test Force Control Manual
Results Display Analog Dial Gage
Vertical Capacity 6.7 in.
Throat Depth 6.6 in.
Height 28 in.
Width 8.9 in.
Depth 19.6 in.
Shipping Weight 190 lbs

  • N-scale Diamond Indentor
  • 1/16" Steel Ball Indentor
  • 3- HRN Test Blocks
  • 3-HRT Test Blocks
  • Test Table 5.87" (150mm)
  • Flat Anvil 2.5" (63mm)
  • Spot Anvil .38" (10mm)
  • Std. Vee Anvil
  • Accessory Case
  • Dust Cover